PCI
Adapter Installation
After installing the CableFREE II hardware, turn on your computer and begin installing the CableFREE II Driver software. Please select your Operating System:
Hardware Installation
PCI Adapter Installation
PCMCIA Adapter Installation
Wireless Hub Installation
|
PCI
Adapter Installation
|
|
| Step 1. Turn off the power to your computer and all peripherals, and unplug the power cord from the wall socket | |
| Step
2. Remove
the computer cover, following the instructions in your computer’s manual
|
|
| Step
3. Select a free PCI expansion slot (PCI slots are usually white;
ISA slots are usually colored black and are longer) and remove the slot
cover
|
|
| Step 4. Carefully install the adapter in the PCI expansion slot by firmly pressing until the adapter is snugly seated. Be sure the adapter is fully home, then fasten the retaining bracket with the screw from the slot cover | |
| Step
5. Replace the computer cover and reconnect any previously disconnected
cables
|
|
| Step
6. Screw the antenna into the CableFREE II PCI adapter
|
|
|
After installing the CableFREE II hardware, turn on your computer and begin installing the CableFREE II Driver software. Please select your Operating System: |
|
| Step
1. Insert the PC Card into the PCMCIA slot of the computer with
the 68-pin connector facing the slot and the label facing up
|
|
| Step 2. Repeat the above procedure for other notebooks to be networked | |
|
After installing the CableFREE II hardware, turn on your computer and begin installing the CableREE II Driver software. Please select your Operating System: |
|
|
Wireless
hub Installation
|
|
| Step
1. To install the CableFREE II Wireless Hub with an Ethernet
device (cable/DSL modem or Ethernet hub), simply connect the CableFREE
II hub to the cable/DSL modem or Ethernet hub via a standard Ethernet network
cable (supplied in the CableFREE II Wireless Hub package)
|
|
| Step
2. Connect the power adapter to the CableFREE II hub and a power
outlet. Note: Use only the power adapter included in the package. Other types of power adapter may damage the CableFREE II hub. |
|
Step
3. Turn on the power. The 
POST LED indicator will blink green during the self-test. If the test is
successful, the LED will turn to a steady green, if not, it will turn to
a steadyred |
|
|
After installing the CableFREE II wireless hub, make sure that you enter the SSID or the ID of the wireless hub found on the bottom of the unit into your CableFREE II Utility. If you have not installed the CableFREE II Utility, please refer to the appropriate instructions for your Operating System: |
|
